2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL CRANKSHAFT POSITION SENSOR

A104548
  1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.

  1. Install the crankshaft position sensor with a bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    Check that the O-ring is not cracked or jammed when installing it onto the timing chain cover.

  1. Connect the connector.


2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← INSPECTION (from Aug 2005)COMPONENTS (from Aug 2005) →