2005-2008 Yaris · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

A093602E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 (+B) - 2 (GND)
      6.9 to 7.9 Ω at 20°C (68°F)

      If the resistance is not as specified, replace the camshaft timing oil control valve.

  1. A076909E03
    Check the operation.

    1. Connect the positive (+) lead from the battery to terminal 1 (+) and the negative (-) lead to terminal 2 (-), then check the movement of the spool valve.

      NOTICE:
      1. Do not bring the positive and negative tester probes too close to each other while using the battery for inspection as short circuit may occur.
      2. Confirm that the spool valve moves freely and does not stick in any position.

      HINT:
      Poor returning of the spool valve resulting from contamination causes subtle pressure leak in the advance direction. In such a case, a DTC will be detected.

← REMOVAL (from Aug 2005)INSTALLATION (from Aug 2005) →