2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

  1. A117319
    Install a vinyl hose onto the radiator side.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly.

  1. Loosen the water drain plug, then drain the coolant.

    A117375E01


3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

A116530E01
  1. Remove the 4 clamps.

  1. Remove the 2 clamps and remove the air cleaner cap.


4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

A116511
  1. Disconnect the 2 water by-pass hoses.

  1. Disconnect the connector.

  1. Remove the 4 bolts and the throttle body.


5. REMOVE THROTTLE BODY GASKET

A104785E01
  1. Remove the gasket from the intake manifold.

← ON-VEHICLE INSPECTION (from Aug 2005)INSPECTION (from Aug 2005) →