2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

NOTICE:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly.

  1. Loosen the cylinder block drain cock plug, then drain the coolant.

    A106596E01


3. REMOVE CYLINDER HEAD COVER NO. 2

A116235
  1. Remove the 4 nuts and cylinder head cover No. 2.


4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE NO. 1

A115124
  1. Disconnect fuel vapor feed hose No. 1 and fuel vapor feed hose No. 2 from the vacuum switching valve assembly.

  1. Disconnect the vacuum switching valve assembly connector and wire harness clamp.

  1. A115123
    Disconnect ventilation hose No. 2.

  1. A115125
    Disconnect the wire harness clamp and mass air flow meter connector.

  1. A115126
    Loosen the hose clamp, unlock the air cleaner assembly clamp and remove air cleaner cap sub-assembly with air cleaner hose No. 1.


5. DISCONNECT WATER BY-PASS HOSE

A115127
  1. Disconnect the water by-pass hose.


6. DISCONNECT WATER BY-PASS HOSE NO. 2

A115128
  1. Disconnect water by-pass hose No. 2.


7. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

A115129
  1. Disconnect the throttle with motor body assembly connector.

  1. Remove the nut and remove the wire harness with bracket.

  1. A115130
    Remove the 2 nuts and remove the water filler sub-assembly with hose.

  1. A115131
    Remove the bolt and 3 nuts and remove the throttle with motor body assembly.

  1. A115132
    Remove the gasket from the intake manifold.


8. REMOVE INTAKE MANIFOLD

A115507
  1. Separate the engine wire harness from the intake manifold.

  1. A115152
    Separate water by-pass hose No. 2.

  1. A115479
    Disconnect the ventilation hose.

  1. A115480
    Disconnect the union to connector tube hose.

  1. A105631
    Remove the 3 bolts and 2 nuts and remove the intake manifold.

  1. Remove the gasket from the intake manifold.


9. REMOVE KNOCK SENSOR

A115481
  1. Disconnect the knock sensor connector.

  1. Remove the nut and remove the knock sensor.

← COMPONENTS (from Aug 2005)INSPECTION (from Aug 2005) →