INSTALLATION
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
![]() ![]() |
Apply a light coat of engine oil to a new O-ring and install it onto the camshaft timing oil control valve assembly.
- NOTICE:
- Do not twist the O-ring.
Install the camshaft timing oil control valve assembly with the bolt.

- Torque:
- 7.5 N*m{ 76 kgf*cm , 66 in.*lbf }
Connect the camshaft timing oil control valve assembly connector.

| 2. INSTALL FAN BELT ADJUSTING BAR |
![]() ![]() |
Provisionally install the fan belt adjusting bar with the bolt and nut.
Tighten the nut to the specified torque.
- Torque:
- 11 N*m{ 112 kgf*cm , 8.1 ft.*lbf }
| 3. INSTALL FAN AND GENERATOR V BELT |
Provisionally install the fan and generator V belt onto each pulley.
- NOTICE:
- Make sure that the V-belt is securely fitted into the rib groove of the pulley.
| 4. ADJUST FAN AND GENERATOR V BELT |
Insert an adjusting bar between the engine mounting bracket and generator assembly. Push the adjusting bar towards the vehicle front to adjust the generator V belt tension.

- NOTICE:
- Do not insert the adjusting bar between the camshaft timing oil control valve assembly and generator assembly. It could damage the camshaft timing oil control valve assembly.
First tighten bolt A, then tighten bolt B.

- Torque:
- 19 N*m{ 189 kgf*cm , 14 ft.*lbf } for bolt A
- 54 N*m{ 551 kgf*cm , 40 ft.*lbf } for bolt B
| 5. INSPECT FAN AND GENERATOR V BELT |
Check the V belt deflection and tension.

- Deflection:
Item
Specified Condition
New belt
7.0 to 8.5 mm (0.28 to 0.33 in)
Used belt
11 to 13 mm (0.43 to 0.51 in)
- Tension:
Item
Specified Condition
New belt
539 to 637 N (55 to 65 kg, 121 to 143 ld)
Used belt
245 to 392 N (25 to 40 kg, 55 to 88 ld)
- HINT:
- Check the V belt deflection at the specified point.
- Check the drive belt deflection at the specified point.
- When installing a new belt, set its tension to the specified value.
- When inspecting a belt which has been used for over 5 minutes, apply the Used Belt specifications.
- When reinstalling a belt which has been used for over 5 minutes, adjust its deflection and tension to the intermediate values of each Used Belt specification.
- V-ribbed belt tension and deflection should be checked after 2 revolutions of engine cranking.
- When using a belt tension gauge, confirm its accuracy by using a master gauge first.
- Check the V belt deflection at the specified point.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
| 7. CHECK FOR ENGINE OIL LEAKAGE |
| 8. INSTALL CYLINDER HEAD COVER NO. 2 |
![]() ![]() |
Tighten 2 A nuts, then 2 B nuts .
- Torque:
- 7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
| 9. INSTALL ENGINE UNDER COVER RH |



