INSTALLATION
Removal / installation · Vehicles built from Aug 2005
| 1.
INSTALL CRANKSHAFT POSITION SENSOR |
 |
Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
Install the crankshaft position sensor with the bolt.
-
Torque:
- 7.5 N*m{
76 kgf*cm
, 66 in.*lbf
}
- NOTICE:
- Do not twist the O-ring.
Connect the crankshaft position sensor connector.
| 2.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 5.4 N*m{
55 kgf*cm
, 48 in.*lbf
}
| 3.
CHECK FOR ENGINE OIL LEAKAGE |
|
| 4.
INSTALL ENGINE UNDER COVER RH |
|