2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2006


1. INSTALL FAN AND GENERATOR V BELT
  1. Provisionally install the fan and generator V belt onto each pulley.

    NOTICE:
    Make sure that the V belt is securely fitted into the rib groove of the pulley.


2. ADJUST FAN AND GENERATOR V BELT

  1. A161127E01
    Turn adjusting bolt C and adjust the tension of the V belt.

    NOTICE:
    Check that bolt D is tightened to the specified torque of 19 N*m (189 kgf*cm, 14 ft.*lbf).

  1. Tighten fixing bolts A and B.

    Torque:
    19 N*m{ 189 kgf*cm , 14 ft.*lbf } for bolt A
    43 N*m{ 438 kgf*cm , 32 ft.*lbf } for bolt B


3. INSPECT FAN AND GENERATOR V BELT

  1. A147660E02
    Check the V belt deflection and tension.

    Deflection:
    Item
    Specified Condition
    New belt
    7.5 to 8.6 mm (0.296 to 0.338 in.)
    Used belt
    8.0 to 10.0 mm (0.315 to 0.397 in.)

    Tension:
    Item
    Specified Condition
    New belt
    688 to 884 N (70 to 90 kg, 155 to 199 ld)
    Used belt
    402 to 598 N (40 to 61 kg, 90 to 134 ld)

    If the belt deflection is not as specified, adjust it.

    HINT:
    1. Check the V belt deflection at the specified point.
    2. When installing a new belt, set its tension to the specified value.
    3. When inspecting a belt which has been used for over 5 minutes, apply the Used Belt specifications.
    4. When reinstalling a belt which has been used for over 5 minutes, adjust its deflection and tension to the intermediate values of the Used Belt specifications.
    5. V belt tension and deflection should be checked after 2 revolutions of engine cranking.
    6. When checking the tension, use a sonic tension meter.

    Input Data for Sonic Tension Meter

    Weight:
    15 g/rib*m

    Width:
    6 ribs (21.36 mm)

    Span:
    188 mm (w/ A/C)
    282 mm (w/o A/C)


4. INSTALL ENGINE UNDER COVER RH

5. INSTALL NO. 2 CYLINDER HEAD COVER

  1. A158207
    Disengage the 4 fittings shown and install the No. 2 cylinder head cover by applying pressure to it.

    HINT:
    Make sure that the oil and the engine oil level dipstick are correctly installed before installing the No. 2 cylinder head cover.

← INSPECTION (from Nov 2006)COMPONENTS (from Nov 2006) →