2005-2008 Yaris · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, then stop the engine and wait for 5 minutes. Check that the engine oil level is between the low and full marks on the oil level gauge.
    If the engine oil level is low, check for oil leakage and add engine oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.


CHECK ENGINE OIL QUALITY

  1. A113813E01
    Check the oil for deterioration, water intrusion, discoloration or thinning.

    Oil grade:
    20W-50 and 15W-40:
    API grade SL or SM multigrade engine oil
    10W-30 and 5W-30:
    API grade SL Energy-Conserving, SM Energy-Conserving or ILSAC multigrade engine oil


REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the engine oil pressure switch connector.

  1. A108582
    for DENSO, YAZAKI made:

    1. Using a 22 mm (0.8661 in.) deep socket wrench, remove the oil pressure switch.

  1. A131381
    for JAEGER made:

    1. Using a 24 mm (0.9449 in.) deep socket wrench, remove the oil pressure switch.


INSTALL OIL PRESSURE GAUGE

  1. A108583
    Install the oil pressure gauge.


CHECK OIL PRESSURE
  1. Warm up the engine.

  1. Check the oil pressure.

    Standard oil pressure:
    Engine rpm
    Oil Pressure
    At 1,000 rpm
    130 kPa (1.3 kgf/cm2, 18.5 psi) or more
    At 4,000 rpm
    350 kPa (3.5 kgf/cm2, 49.8 psi) or more


REMOVE OIL PRESSURE GAUGE
  1. Remove the oil pressure gauge.


INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

  1. A050082E04
    Apply adhesive to the 2 or 3 end threads of the oil pressure switch.

    Adhesive:
    Toyota genuine adhesive 1324, Three bond 1324 or Equivalent.

  1. A108582
    for DENSO, YAZAKI made:

    1. Using a 22 mm (0.8661 in.) deep socket wrench, install the oil pressure switch.

      Torque:
      15 N*m{ 153 kgf*cm , 11 ft.*lbf }

      NOTICE:
      Do not start the engine for at least 1 hour after the installation.

  1. A131381
    for JAEGER made:

    1. Using a 24 mm (0.9449 in.) deep socket wrench, install the oil pressure switch.

      Torque:
      15 N*m{ 153 kgf*cm , 11 ft.*lbf }

      NOTICE:
      Do not start the engine for at least 1 hour after the installation.

  1. Connect the oil pressure switch connector.


CHECK FOR ENGINE OIL LEAKAGE
← INSTALLATION (from Jan 2006)COMPONENTS (from Nov 2005) →