2005-2008 Yaris · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2006


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, then stop the engine and wait for 5 minutes. Check that the engine oil level is between the low and full marks on the oil level gauge.
    If the engine oil level is low, check for oil leakage and add engine oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.


CHECK ENGINE OIL QUALITY
  1. Check the oil for deterioration, water intrusion, discoloration or thinning.
    If the quality is visibly poor, replace the oil and oil filter.


REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the engine oil pressure switch assembly connector.

  1. A147670
    Using a 24 mm deep socket wrench, remove the oil pressure switch.


INSTALL OIL PRESSURE GAUGE

A147671E01
  1. Install the oil pressure gauge.


CHECK OIL PRESSURE
  1. Warm up the engine.

  1. Check the oil pressure.

    Standard oil pressure:
    Engine rpm
    Oil Pressure
    When idling
    25 kPa (0.3 kgf/cm2, 3.7 psi) or more
    At 3,000 rpm
    150 to 400 kPa (1.6 to 4.1 kgf/cm2, 21.8 to 58.0 psi) or more


REMOVE OIL PRESSURE GAUGE
  1. Remove the oil pressure gauge.


INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

A050082E04
  1. Apply adhesive to the 2 or 3 end threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. A147670
    Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after the installation.

  1. Connect the oil pressure switch assembly connector.


INSPECT FOR ENGINE OIL LEAK
← INSTALLATION (from Nov 2005)COMPONENTS (from Nov 2006) →