2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE COOLANT

NOTICE:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly.

  1. Loosen the cylinder block drain cock plug, then drain the coolant.

    A106596E01


3. REMOVE ENGINE UNDER COVER RH

4. REMOVE FAN AND GENERATOR V BELT

  1. A116197E01
    Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.


5. REMOVE GENERATOR ASSEMBLY

A115418
  1. Remove the terminal cap.

  1. Separate the connector and harness clamp.

  1. Remove the nut and remove terminal B.

  1. A115419E01
    Remove fan belt adjusting slider fixing bolts A and B and remove the fan belt adjusting slider.

  1. A115420E01
    Remove fixing bolt B and remove the generator.


6. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

A116236
  1. Place a wooden block on a jack underneath the engine.

  1. G100143
    Remove the 5 bolts and nut and remove the engine mounting insulator sub-assembly RH.


7. REMOVE WATER PUMP PULLEY

A116191E01
  1. Using SST, hold the water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)

  1. Remove the 3 bolts and remove the water pump pulley.


8. REMOVE WATER PUMP ASSEMBLY

A116192
  1. Remove the 3 bolts and 2 nuts and remove the water pump assembly and gasket.

← COMPONENTS (from Jan 2006)INSPECTION (from Aug 2005) →