2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jan 2006


INSPECT HAZARD WARNING SIGNAL SWITCH

  1. E127123
    Check the resistance.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 - 15
      OFF
      10 kΩ or higher
      4 - 15
      ON
      Below 1 Ω
      3 - 13
      Illumination circuit
      Below 1 Ω

      If the result is not as specified, replace the hazard warning signal switch.

  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 13 and the negative (-) battery lead to terminal 3, then check that the illumination illuminates.

      Standard:
      Illumination illuminates.

      If the illumination does not illuminate, replace the hazard warning signal switch.

← REMOVAL (from Jan 2006)INSTALLATION (from Jan 2006) →