INSPECTION
Inspection · Vehicles built from Aug 2005
| INSPECT HEADLIGHT LEVELING SWITCH |
![]() ![]() |
Check the ratio.
Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 4.
Check the ratio which is obtained by dividing the voltage between terminals 2 and 4 by the voltage between 1 and 4. The voltages must be measured using a voltmeter.
- Standard Ratio:
Tester Connection
Switch Position
Specified Condition
1 - 4 and 2 - 4
0
0.87 to 0.93
1 - 4 and 2 - 4
1
0.76 to 0.82
1 - 4 and 2 - 4
2
0.66 to 0.72
1 - 4 and 2 - 4
3
0.55 to 0.61
1 - 4 and 2 - 4
4
0.44 to 0.50
1 - 4 and 2 - 4
5
0.34 to 0.40
Check the illumination operation.
Connect the positive (+) battery lead to terminal 3 and the negative (-) battery lead to terminal 4, then check that the illumination illuminates.
- Standard:
- Illumination illuminates.


