INSPECTION
Inspection · Vehicles built from Jan 2006
| INSPECT HEADLIGHT LEVELING SWITCH |
![]() ![]() |
Check the ratio.
Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 4.
Check the ratio which is obtained by dividing the voltage between terminals 2 and 4 (V1) by the voltage between 1 and 4 (V2). The voltages must be measured using a voltmeter.
- HINT:
- The switch position can be adjusted in step of 0.5.
- Standard Ratio:
Tester Connection
Switch Position
Specified Condition
1 - 4 and 2 - 4
0
0.87 to 0.93
0.5
0.79 to 0.85
1
0.71 to 077
1.5
0.63 to 0.69
2
0.55 to 0.61
2.5
0.47 to 0.533
3
0.39 to 0.45
3.5
0.31 to 0.37
4
0.23 to 0.29
4.5
0.15 to 0.21
5
0.07 to 0.13
Check the illumination operation.
Connect the positive (+) battery lead to terminal 3 and the negative (-) battery lead to terminal 4, then check that the illumination illuminates.
- Standard:
- Illumination illuminates.


