INSTALLATION
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL STOP LIGHT SWITCH |
Install the stop light switch into the adjuster until it slightly touches the brake pedal.

- NOTICE:
- Do not depress the brake pedal.
Make a quarter turn clockwise to install the stop light switch.

- NOTICE:
- Do not depress the brake pedal.
- HINT:
- The turning torque for installing the stop light switch is as below.
- Torque:
- 1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less
Check the stop light switch clearance.
- Stop light switch clearance:
- 1.5 to 2.5 mm (0.059 to 0.098 in.)
Connect the stop light switch connector to the stop light switch.

| 2. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Engage the 3 claws and install the instrument panel under cover.

Tighten the 2 screws.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
