INSTALLATION
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL FRONT DOOR COURTESY SWITCH |
![]() ![]() |
Connect the connector.
Using "Torx" socket wrench T30, install the front door courtesy switch with the screw.
- Torque:
- 3.7 N*m{ 38 kgf*cm , 33 in.*lbf }
| 2. INSTALL CENTER PILLAR GARNISH LOWER (for 5 Door) |
Engage the 2 clips and the 2 claws and install the center pillar lower garnish.

| 3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP (for 5 Door) |
![]() ![]() |
Install the rear door opening trim weatherstrip.
| 4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() ![]() |
Install the front door opening trim weatherstrip.
| 5. INSTALL REAR DOOR SCUFF PLATE (for 5 Door) |
- HINT:
- Use the same procedure as for the RH side.
| 6. INSTALL FRONT DOOR SCUFF PLATE (for 5 Door) |
- HINT:
- Use the same procedure as for the RH side.
| 7. INSTALL FRONT DOOR SCUFF PLATE (for 3 Door) |
- HINT:
- Use the same procedure as for the RH side.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



