REMOVAL
Removal / installation · Vehicles built from Aug 2005
- HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- Use the same procedure for both the RH and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR SCUFF PLATE (for 5 Door) |
- HINT:
- Use the same procedure as for the RH side.
| 3. REMOVE FRONT DOOR SCUFF PLATE (for 3 Door) |
- HINT:
- Use the same procedure as for the RH side.
| 4. REMOVE REAR DOOR SCUFF PLATE (for 5 Door) |
- HINT:
- Use the same procedure as for the RH side.
| 5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() ![]() |
Remove the front door opening trim weatherstrip.
| 6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP (for 5 Door) |
![]() ![]() |
Remove the rear door opening trim weatherstrip.
| 7. REMOVE CENTER PILLAR GARNISH LOWER (for 5 Door) |
Disengage the 2 clips and the 2 claws and remove the center pillar lower garnish.

| 8. REMOVE FRONT DOOR COURTESY SWITCH |
![]() ![]() |
Using "Torx" socket wrench T30, remove the screw.
Disconnect the connector and remove the front door courtesy switch.



