2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL REAR WIPER MOTOR

E114458E01
  1. Install the rear wiper motor with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.


2. INSTALL REAR WIPER MOTOR GROMMET

E107901
  1. Install the rear wiper motor grommet.


3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

E058837E10
  1. Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).

  1. Clean the wiper pivot serrations with a wire brush.

  1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

  1. E107904E01
    Install the rear wiper arm into the position shown in the illustration with the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    HINT:
    Hold the arm hinge down by hand while tightening the nut.

  1. E107903
    Close the rear wiper arm head cap.


4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

B118076
  1. Engage the 3 claws and 9 clips and install the back door trim board.

  1. B104995
    Slide the handle plate of the back door trim board to engage it.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← INSPECTION (from Aug 2005)COMPONENTS (from Nov 2005) →