INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1.
INSTALL NO. 1 REAR WIPER LINK PIVOT WASHER |
 |
Install the rear wiper motor grommet.
| 2.
INSTALL REAR WIPER MOTOR COVER (w/ Cover) |
 |
Install the rear wiper motor cover.
| 3.
INSTALL REAR WIPER MOTOR |
 |
Install the rear wiper motor with the 3 bolts.
-
Torque:
- 5.5 N*m{
56 kgf*cm
, 49 in.*lbf
}
Connect the connector.
| 4.
INSTALL REAR WIPER ARM AND BLADE ASSEMBLY |
 |
Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).
Clean the wiper pivot serrations with a wire brush.
Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
- Install the rear wiper arm into the position shown in the illustration with the nut.
-
Torque:
- 15 N*m{
153 kgf*cm
, 11 ft.*lbf
}
- HINT:
- Hold the arm hinge down by hand while tightening the nut.
- Close the rear wiper arm head cap.
| 5.
INSTALL BACK DOOR TRIM BOARD ASSEMBLY
|
 |
Engage the 3 claws and 9 clips and install the back door trim board.
- Slide the handle plate of the back door trim board to engage it.
| 6.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 5.4 N*m{
55 kgf*cm
, 48 in.*lbf
}