REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() ![]() |
Using a screwdriver with its tip wrapped in protective tape, slide the handle plate of the back door trim board to disengage it.
Disengage the 3 claws and 9 clips and remove the back door trim board.

| 3. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY |
![]() ![]() |
Open the rear wiper arm head cap.
Remove the nut and rear wiper arm and blade.

| 4. REMOVE REAR WIPER MOTOR GROMMET |
![]() ![]() |
Remove the rear wiper motor grommet.
| 5. REMOVE REAR WIPER MOTOR |
![]() ![]() |
Disconnect the connector.
Loosen bolt A.
- NOTICE:
- Do not try to remove the bolt since it is integrated with the motor.
Remove bolt B and the rear wiper motor.




