2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE BACK DOOR TRIM BOARD ASSEMBLY

B104993
  1. Using a screwdriver with its tip wrapped in protective tape, slide the handle plate of the back door trim board to disengage it.

  1. B118076
    Disengage the 3 claws and 9 clips and remove the back door trim board.


3. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY

E107899
  1. Open the rear wiper arm head cap.

  1. E107900
    Remove the nut and the rear wiper arm and blade.


4. REMOVE REAR WIPER MOTOR

E125997E01
  1. Disconnect the connector.

  1. Loosen bolt A.

    NOTICE:
    Do not try to remove the bolt since it is integrated with the motor.

  1. Remove the 2 B bolts and the rear wiper motor.


5. REMOVE REAR WIPER MOTOR COVER (w/ Cover)

E125998
  1. Remove the rear wiper motor cover.


6. REMOVE NO. 1 REAR WIPER LINK PIVOT WASHER

E125996
  1. Remove the rear wiper motor grommet.

← ON-VEHICLE INSPECTION (from Nov 2005)INSPECTION (from Nov 2005) →