REMOVAL
Removal / installation · Vehicles built from Aug 2005
- HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- Use the same procedure for both the RH and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE DOOR ARMREST COVER |
![]() ![]() |
for 5 Door:
Using a screwdriver with its tip wrapped in protective tape, disengage the 8 claws and 3 clips and remove the door armrest cover.
for 3 Door:

Disengage the 12 claws and 3 clips and remove the door armrest cover.
| 3. REMOVE FRONT ARMREST BASE PANEL UPPER |
![]() ![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and clip and remove the front armrest base panel upper.
Disconnect the connector.
| 4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
![]() ![]() |
Remove the 3 screws and the power window regulator master switch.



