2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL STARTER ASSEMBLY

A104498
  1. Install the starter assembly with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Connect the connector.

  1. Connect terminal 30 with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7.2 ft.*lbf }

  1. Close the terminal cap.


2. INSTALL FLYWHEEL HOUSING SIDE COVER

A104497E04
  1. Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

    NOTICE:
    1. Make sure that the claw makes a click sound, indicating that it fits tightly.
    2. Replace the claw with a new one if it does not fit tightly or is deformed.


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REASSEMBLY (from Aug 2005)ON-VEHICLE INSPECTION (from Aug 2005) →