2005-2008 Yaris · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Nov 2005

CAUTION:
  1. Prolonged and repeated contact with engine oil will result in the removal of natural oils from the skin, leading to dryness, irritation and dermatitis. Used engine oil contains potentially harmful contaminants which may cause skin cancer.
  2. Take precautions when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves that cannot be penetrated by oil. Wash skin with soap and water, or use waterless hand cleaner, to remove any used engine oil completely. Do not use gasoline, thinner, or solvents.
  3. Dispose of used oil and used oil filters at designated disposal sites in order to preserve the environment.


1. DRAIN ENGINE OIL
  1. Remove the oil pan drain plug and drain the engine oil.

  1. Clean the oil pan drain plug and install it with a new gasket.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }


2. REMOVE OIL FILTER SUB-ASSEMBLY

  1. A109214E01
    Using SST, remove the oil filter.
    SST
    09228-06501  


3. INSTALL OIL FILTER SUB-ASSEMBLY
  1. Check and clean the oil filter installation surface.

  1. Apply clean engine oil to the O-ring of a new oil filter.

  1. A109215E01
    Gently screw the oil filter into place, then tighten it until the gasket comes into contact with the seat.

  1. Using SST, tighten the oil filter.

    SST
    09228-06501  

    1. Depending on the work space available, choose from the following.
      If enough space is available, use a torque wrench to tighten the oil filter.

      Torque:
      13 N*m{ 133 kgf*cm , 9.5 ft.*lbf }

      If enough space is not available to use a torque wrench, tighten the oil filter a 3/4 turn by hand or by a common wrench.


4. ADD ENGINE OIL
  1. Fill with new engine oil.

    Oil capacity:
    Item
    Capacity
    With oil filter change
    3.2 liters (3.4 US qts, 2.8 lmp. qts)
    Without oil filter change
    2.9 liters (3.1 US qts, 2.6 lmp. qts)
    Dry fill
    3.6 liters (3.8 US qts, 3.2 lmp. qts)


5. CHECK FOR ENGINE OIL LEAKAGE

6. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, then stop the engine and wait for 5 minutes. Check that the engine oil level is between the low and full marks on the oil level gauge.
    If the engine oil level is low, check for oil leakage and add engine oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.

← COMPONENTS (from Nov 2005)COMPONENTS (from Nov 2005) →