2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. REMOVE REAR WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


3. DISCONNECT PARKING BRAKE CABLE ASSEMBLY

C129757
  1. Disconnect the cable end from the rear disc brake cylinder operation lever.

  1. Using needle-nose pliers, disengage the claws of the casing cap and disconnect the parking brake cable.


4. SEPARATE REAR FLEXIBLE HOSE

C129758
  1. Remove the union bolt and gasket and separate the flexible hose from the disc brake cylinder.


5. REMOVE REAR DISC BRAKE ANTI-RATTLE SPRING

C129759
  1. Remove the spring from the disc brake cylinder.


6. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY

C129760
  1. Remove the 2 slide bolt caps.

  1. C129761
    Using "Torx" socket wrench T45, remove the 2 slide bolts and remove the disc brake cylinder.


7. REMOVE REAR DISC BRAKE PAD

C129762
  1. Remove the 2 disc brake pads from the disc brake cylinder mounting.


8. REMOVE REAR DISC BRAKE BUSH DUST BOOT

C129763
  1. Remove the 2 dust boots from the disc brake cylinder.


9. REMOVE REAR DISC BRAKE CYLINDER MOUNTING

C129764
  1. Remove the 2 bolts and remove the disc brake cylinder mounting from the axle beam.


10. REMOVE REAR DISC

C108951E01
  1. Place matchmarks on the disc and axle hub and remove the disc.

← COMPONENTS (from Nov 2005)DISASSEMBLY (from Nov 2005) →