2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2005 – Dec 2005

Versions by build date: Aug 2005 – Dec 2005 from Jan 2006


1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE CYLINDER HEAD COVER NO. 2

A116235E01
  1. Tighten 2 A nuts, then 2 B nuts .

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }


4. REMOVE IGNITION COIL NO. 1

A115484
  1. Disconnect the 4 ignition coil connectors.

  1. A115485
    Remove the 4 bolts and 4 ignition coils.


5. REMOVE VENTILATION HOSE

A115487
  1. Disconnect the ventilation hose.


6. REMOVE VENTILATION HOSE NO. 2

A115488
  1. Disconnect ventilation hose No. 2.


7. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

A115489
  1. Disconnect the fuel injector connectors.

  1. A116181
    Disconnect the connector and 3 wire harness clamps shown in the illustration and disconnect the engine wire harness.

  1. A066472E01
    Remove the 9 bolts, 2 nuts and 2 seal washers and then remove the cylinder head cover sub-assembly.


8. DISCONNECT FUEL TUBE SUB-ASSEMBLY

A115492
  1. Remove the fuel pipe clamp.

  1. A117474E01
    Pinch the retainer of the fuel tube connector, then pull out the fuel tube connector to disconnect the fuel tube from the fuel delivery pipe sub-assembly.

    NOTICE:
    1. Remove any dirt and foreign matter from the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign matter on the parts when disconnecting as the fuel tube connector has the O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Protect the disconnected parts by covering them with vinyl bags after disconnecting the fuel tube.
    6. If the fuel tube connector and pipe are stuck, push and pull to release them.


9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

A115494
  1. Remove the 3 bolts and remove the fuel delivery pipe sub-assembly with the 4 fuel injectors.

    NOTICE:
    Do not drop the fuel injectors when removing the fuel delivery pipe sub-assembly.


10. REMOVE DELIVERY PIPE NO. 1 SPACER

A115496
  1. Remove the 2 delivery pipe No. 1 spacers.


11. REMOVE INJECTOR VIBRATION INSULATOR

A115497
  1. Remove the 4 injector vibration insulators.


12. REMOVE FUEL INJECTOR ASSEMBLY

A115498E01
  1. Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.

← COMPONENTS (from Jan 2006)REMOVAL (from Jan 2006) →