2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL NO. 3 INSTRUMENT PANEL CUSHION

B108205
  1. Install the 2 instrument panel cushions onto the instrument panel upper.


2. INSTALL NO. 2 INSTRUMENT PANEL CUSHION

B108204
  1. Install the instrument panel cushion onto the instrument panel upper.


3. INSTALL NO. 1 INSTRUMENT PANEL CUSHION

B108203
  1. Install the instrument panel cushion onto the instrument panel upper.


4. INSTALL INSTRUMENT PANEL CUSHION

B108180
  1. Install the instrument panel cushion onto the instrument panel upper.


5. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

B108295E01
  1. Engage the 10 hooks so that the connector side faces the outside of the vehicle, and install the instrument panel passenger airbag.

  1. Install the wire harness onto the 2 claws of the instrument panel.


6. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

B108178
  1. Engage the 3 claws and install the register.

    HINT:
    Use the same procedure as for the opposite side.


7. INSTALL NO. 1 HEATER TO REGISTER DUCT

B108176
  1. Install the register duct No. 1 with the 2 <A> screws.


8. INSTALL NO. 2 HEATER TO REGISTER DUCT

B108177
  1. Install the register duct No. 2 with the 2 <A> screws.


9. INSTALL NO. 1 INSTRUMENT PANEL CUP HOLDER

B108175
  1. Engage the hinge portion of the cup holder and install the cup holder.

  1. B108174
    Engage the stopper of the cup holder.


10. INSTALL NO. 2 INSTRUMENT PANEL CUP HOLDER

HINT:
Use the same procedure as for the RH side.


11. INSTALL INSTRUMENT PANEL CUP HOLDER SPRING

B105360
  1. Install the cup holder spring with screw <A>.


12. INSTALL NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

B105359
  1. Engage the 2 claws and 2 clips.

  1. Instal the box door with the 2 <A> screws.


13. INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

B105357
  1. Engage the 2 claws and 2 clips.

  1. Install the box door with the 2 <A> screws.


14. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

B108233E01
  1. Using a nipper, cut off both ends of the runner portion shown in the illustration (When installing a new one).

  1. Engage the 5 claws at the upper side of the instrument panel.

  1. Engage the claw and the 3 clips at the lower side of the instrument panel.

    B105355E01

  1. Install the instrument panel upper with the 2 <C> bolts and the 4 <B> screws.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf } for bolt

  1. Connect the connectors.

    B105354E01

  1. B108182
    Connect the passenger airbag connector and clamp.


15. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

B105352
  1. Engage the claw of the hinge portion in the horizontal direction to install the glove compartment door assembly.

    NOTICE:
    Engage the claw in the horizontal direction, otherwise, installation failure caused by excessive play around the hinge portion will result.

  1. B108202
    Slightly deform the upper portion of the glove compartment door assembly to engage the stopper.


16. INSTALL NO. 1 SWITCH HOLE BASE

B108201
  1. Disengage the 2 clips and 2 claws and install the switch hole base.


17. INSTALL FRONT PILLAR GARNISH RH

  1. B114342E01
    w/ Curtain Shield Airbag:

    1. Remove the piece of cloth or nylon.

  1. B127672
    w/ Front No. 2 Speaker:

    1. Insert the hook into the body hole.

    2. Engage the clip and install the front speaker.

    3. B127674
      Connect the speaker connector.

  1. B114312
    Install the 3 antenna cord clamps.

  1. Connect the connector.

  1. w/ Curtain Shield Airbag:

    1. B117697E01
      Install a new special clip and the clip onto a new front pillar garnish.

    2. Engage the 2 clips and the 2 claws and install the front pillar garnish.

  1. w/o Curtain Shield Airbag:

    1. B117694
      Engage the 2 clips and the 2 claws and install the front pillar garnish.


18. INSTALL FRONT PILLAR GARNISH LH

  1. B114344E01
    w/ Curtain Shield Airbag:

    1. Remove the piece of cloth or nylon.

  1. B127671
    w/ Front No. 2 Speaker:

    1. Insert the hook into the body hole.

    2. Engage the clip and install the front speaker.

    3. B127673
      Connect the speaker connector.

  1. B114316
    Install the 4 wire harness clamps.

  1. w/ Curtain Shield Airbag:

    1. B117698E01
      Install a new special clip and the clip onto a new front pillar garnish.

    2. Engage the 2 clips and the 2 claws and install the front pillar garnish.

  1. w/o Curtain Shield Airbag:

    1. B114318
      Engage the 2 clips and the 2 claws and install the front pillar garnish.


19. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
  1. Install the front door opening trim weatherstrip.


20. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Install the front door opening trim weatherstrip.


21. INSTALL COMBINATION METER ASSEMBLY

E107730
  1. Install the combination meter assembly with the 2 screws.

  1. Connect the 2 connectors.


22. INSTALL INSTRUMENT CLUSTER FINISH PANEL

B132366E01
  1. Fit the 3 A claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.

  1. B132367
    Engage the 4 claws and 5 clips and install the instrument cluster finish panel.


23. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

E107743
  1. with CD player

    1. Connect the connector.

    2. Engage the 4 claws and 3 clips and install the instrument panel finish panel end RH.

  1. E107744
    Except CD player

    1. Connect the connector.

    2. Engage the 5 claws and 3 clips and install the instrument panel finish panel end RH.


24. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

E107741
  1. with CD player

    1. Connect the connector.

    2. Engage the 4 claws and 3 clips and install the instrument panel finish panel end LH.

  1. E107742
    Except CD player

    1. Connect the connector.

    2. Engage the 5 claws and 3 clips and install the instrument panel finish panel end LH.


25. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


26. CHECK SRS WARNING LIGHT
(Click here)
← REMOVAL (from Aug 2005)COMPONENTS (from Jan 2006) →