2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

A104560
  1. Remove the nut, and disconnect the lead wire from the magnetic switch terminal.

  1. Loosen the 2 nuts holding the magnetic switch onto the starter housing.

  1. A117330
    Pull the magnetic switch and while lifting the front part of the magnetic switch, release the plunger hook from the driver lever, then remove the magnetic switch.


2. REMOVE STARTER YOKE ASSEMBLY

A104562
  1. Remove the 2 through bolts, and pull out the field frame together with the armature.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

A108476
  1. Remove the 2 screws and commutator end frame, and hold down the lead wire while releasing the commutator end frame.

    NOTICE:
    To avoid interference between the brush holder and the dust protector, pull the commutator end frame away at an angle.

  1. A033588
    Using a screwdriver, hold the spring back and disconnect the brush holder.

  1. Disconnect the 4 brushes, and remove the brush holder.


4. REMOVE STARTER ARMATURE ASSEMBLY

5. REMOVE STARTER CLUTCH SUB-ASSEMBLY

A117331
  1. Remove the drive lever and starter clutch together with the shock absorber from the starter housing.

  1. A033589
    Using a screwdriver, tap in the stop collar toward the starter clutch.

  1. A033590
    Using a screwdriver, pry off the snap ring.

  1. Remove the rear collar and starter clutch from the planetary shaft.

← REMOVAL (from Aug 2005)INSPECTION (from Aug 2005) →