2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. INSTALL STARTER CLUTCH SUB-ASSEMBLY
  1. Apply grease to the bushing and spline of the starter clutch and stop collar.

  1. A033607
    Place the starter clutch and stop collar on the planetary shaft.

  1. Apply grease to a new snap ring, and install it onto the planetary shaft groove.

  1. A033608E01
    Using a vise, compress the snap ring.

  1. A033587
    Hold the starter clutch, tap the planetary shaft and install the stop collar onto the snap ring with a plastic-faced hammer.

  1. A117331E01
    Apply grease to the drive lever that is in contact with the starter pivot part of the drive lever.

  1. Install the drive lever onto the starter clutch.

  1. A117332E01
    Align the matchmarks on the shock absorber and starter housing.

  1. Install the shock absorber onto the starter housing.


2. INSTALL STARTER ARMATURE ASSEMBLY

3. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Install the brush holder.

  1. A033588
    Using a screwdriver, hold the brush spring back, and connect the 4 brushes to the brush holder.

  1. Apply turbine oil with additives to the bearing of the end frame.

  1. A108476
    Install the end frame with 2 new screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

    NOTICE:
    To avoid interference between the brush holder and the dust protector, push the commutator and frame away at an angle.


4. INSTALL STARTER YOKE ASSEMBLY

A117333E01
  1. Align the cutout of the field frame with the protrusion of the shock absorber.

  1. A104562
    Install the field frame and armature assembly with the 2 through bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }


5. INSTALL MAGNET STARTER SWITCH ASSEMBLY

A117330
  1. Hang the plunger of the magnetic switch onto the driver lever from the upper side.

  1. A064791
    Install the magnetic switch with the 2 nuts.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

  1. A064790
    Connect the lead wire to the terminal with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

← INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →