2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Nov 2006


1. INSTALL REAR SPOILER

  1. Clean the rear spoiler (When reusing the rear spoiler).

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the back door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the rear spoiler while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided adhesive tape remains on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using a non-residue solvent, clean the rear spoiler.

    4. B160136E01
      Apply new double-sided adhesive tape to the rear spoiler installation surface as shown in the illustration.
      Tape A size: 
      a
      250 mm (9.843 in.)
      b
      8 mm (0.315 in.)
      c
      1.6 mm (0.063 in.)
      Tape B size: 
      a
      20 mm (0.787 in.)
      b
      8 mm (0.315 in.)
      c
      1.6 mm (0.063 in.)

  1. Clean the attachment surface.

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the back door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the back door panel while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided adhesive tape remains on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using a non-residue solvent, clean the attachment surface.

  1. B160135E01
    Engage the 2 clips and the 2 pins and install the rear spoiler.

  1. Press the rear spoiler against the vehicle to apply the double-sided adhesive tape.

  1. B160134
    Install the 2 screws.


2. INSTALL REAR SPOILER COVER LH

  1. B117716E01
    Engage the 2 claws and install the rear spoiler cover.

    NOTICE:
    When installing the rear spoiler cover, first engage claw A nearest the outside of the vehicle and then push in claw B nearest the inside of the vehicle.


3. INSTALL REAR SPOILER COVER RH

HINT:
Use the same procedure as for the LH side.

← REMOVAL (from Nov 2006)COMPONENTS (from Jan 2006) →