2005-2008 Yaris · Service Manual COMMUNICATION SYSTEM

Center Airbag Sensor Communication Stop Mode

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
Center Airbag Sensor Communication Stop Mode
  1. "SRS Airbag" not displayed on "Communication Bus Check" screen of intelligent tester
  2. Applies to "Center Airbag Sensor Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of center airbag sensor assembly
  2. Center airbag sensor assembly branch wire or connector
  3. Center airbag sensor assembly

WIRING DIAGRAM

C118188E03

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

    HINT:
    Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE)

  1. C131069E06
    Turn the ignition switch off.

  1. Disconnect the D16 center airbag sensor assembly connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D16-13 (CANH) - D16-22 (CANL)
    Ignition Switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO CENTER AIRBAG SENSOR ASSEMBLY (CAN-H, CAN-L)
OK


2. CHECK HARNESS AND CONNECTOR (IG2, E1, E2)

  1. C131069E07
    Disconnect the D16 center airbag sensor assembly connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D16-25 (E1) - Body ground
    Always
    Below 1 Ω
    D16-26 (E2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D16-21 (IG2) - Body ground
    Ignition Switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY


← Certification ECU Communication Stop Mode (from Aug 2005)Check CAN Bus Line (LHD Models) (from Aug 2005) →