2005-2008 Yaris · Service Manual COMMUNICATION SYSTEM

Main Body ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
Main Body ECU Communication Stop Mode
  1. "Integrated J/B" not displayed on "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Main Body ECU Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of main body ECU
  2. Main body ECU branch wire or connector
  3. Main body ECU

WIRING DIAGRAM

C118189E08

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

    HINT:
    Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (MAIN BODY ECU BRANCH WIRE)

  1. C131839E01
    w/ Entry and start system:
    1. Turn the ignition switch off.

    2. Disconnect the D66 main body ECU connector.

    3. Measure the resistance.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      D66-15 (CANH) - D66-16 (CANL)
      Ignition switch off
      54 to 69 Ω

  1. C131840E01
    w/o Entry and start system:
    1. Turn the ignition switch off.

    2. Disconnect the D33 main body ECU connector.

    3. Measure the resistance.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      D33-23 (CANH) - D33-22 (CANL)
      Ignition switch off
      54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO MAIN BODY ECU (CAN-H, CAN-L)
OK


2. CHECK HARNESS AND CONNECTOR (BECU, IG, GND1)

  1. G100284E01
    Disconnect the 4B and 4Emain body ECU connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    4E-17 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    4B-30 (BECU) - Body ground
    Always
    10 to 14 V

  1. Reconnect the main body ECU connectors.

  1. C127390E02
    Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    4B-24 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← Transmission Control ECU and ECM Communication Stop Mode (from Nov 2005)Combination Meter ECU Communication Stop Mode (from Aug 2005) →