REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Fog Light) |
| 2. REMOVE FRONT SPOILER COVER LH (w/ Front Spoiler) |
Remove the 5 screws and the front spoiler cover.

| 3. REMOVE FRONT SPOILER COVER RH (w/ Front Spoiler) |
Remove the 4 screws and the front spoiler cover.

| 4. REMOVE FRONT BUMPER COVER |
Apply protective tape as shown in the illustration.

w/ Front Spoiler:

Remove the 3 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/o Front Spoiler:

Remove the 8 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/ Fog Light:

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper.
Disconnect the 2 fog light connectors.
w/o Fog Light:

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper.
| 5. REMOVE RADIATOR GRILLE EMBLEM |
Disengage the 4 claws and remove the radiator grille emblem.

| 6. REMOVE SYMBOL EMBLEM |
Apply protective tape to the back door panel in the area around the symbol emblem.

Using an infrared light, heat the symbol emblem.

- CAUTION:
- Do not burn yourself with the heated back door panel or infrared light.
- HINT:
- Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
Using a gasket scraper with its tip wrapped in protective tape, gradually peel the adhesive surface and remove the symbol emblem.
Remove the protective tape.
| 7. REMOVE NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE |
Apply protective tape to the back door panel in the area around the No. 1 luggage compartment door name plate.

Using an infrared light, heat the No. 1 luggage compartment door name plate.

- CAUTION:
- Do not burn yourself with the heated back door panel or infrared light.
- HINT:
- Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
Using a gasket scraper with its tip wrapped in protective tape, gradually peel the adhesive surface and remove the No. 1 luggage compartment door name plate.
Remove the protective tape.
| 8. REMOVE NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE |
Apply protective tape to the back door panel in the area around the No. 2 luggage compartment door name plate.

Using an infrared light, heat the No. 2 luggage compartment door name plate.

- CAUTION:
- Do not burn yourself with the heated back door panel or infrared light.
- HINT:
- Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
Using a gasket scraper with its tip wrapped in protective tape, gradually peel the adhesive surface and remove the No. 2 luggage compartment door name plate.
Remove the protective tape.
