REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT SPOILER COVER LH (w/ Front Spoiler) |
Remove the 5 screws and the front spoiler cover.

| 3. REMOVE FRONT SPOILER COVER RH (w/ Front Spoiler) |
Remove the 4 screws and the front spoiler cover.

| 4. REMOVE FRONT BUMPER COVER |
Apply protective tape as shown in the illustration.

w/ Front Spoiler:

Remove the 3 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/o Front Spoiler:

Remove the 8 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/ Fog Light:

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
w/o Fog Light:

Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
w/ Front Spoiler:

Remove the 2 clips and the 4 screw grommets.
w/o Front Spoiler:

Remove the 2 clips and the screw grommet.
| 5. REMOVE HEADLIGHT ASSEMBLY LH |
![]() ![]() |
Remove the 3 screws.
w/ Headlight leveling:
Disconnect the 4 connectors, then remove the headlight.
w/o Headlight leveling:
Disconnect the 3 connectors, then remove the headlight.
| 6. REMOVE HEADLIGHT ASSEMBLY RH |
- HINT:
- Use the same procedure as for the LH side.
| 7. REMOVE FRONT BUMPER SIDE RETAINER LH |
Remove the screw.

Using a clip remover, disengage the 2 claws and remove the front bumper side retainer.
| 8. REMOVE FRONT BUMPER SIDE RETAINER RH |
- HINT:
- Use the same procedure as for the LH side.
| 9. REMOVE RADIATOR SUPPORT UPPER ABSORBER |
Using a screwdriver, disengage the 6 claws and remove the radiator support upper absorber.

| 10. REMOVE ENGINE UNDER COVER LH (w/ Front Bumper Lower Absorber) |
Remove the 3 screws and the engine under cover.

| 11. REMOVE ENGINE UNDER COVER RH (w/ Front Bumper Lower Absorber) |
Remove the 2 screws and the engine under cover.

| 12. REMOVE FRONT BUMPER LOWER ABSORBER (w/ Front Bumper Lower Absorber) |
Using a clip remover, remove the 6 clips.

Remove the 4 screws and the front bumper absorber lower.
| 13. REMOVE RADIATOR SIDE AIR SEAL LH |
except G. C. C. Countries:

Disengage the 2 claws and remove the radiator side air seal.
for G. C. C. Countries:

Disengage the 2 claws and remove the radiator side air seal.
| 14. REMOVE RADIATOR SIDE AIR SEAL RH |
- HINT:
- Use the same procedure as for the LH side.
| 15. REMOVE THERMISTOR ASSEMBLY (w/ Air Conditioning System) |
Remove the clamp.

Remove the thermistor.
| 16. REMOVE RADIATOR SUPPORT EXTENSION LH |
w/o Air Conditioning System (LH Side Only):

Remove the clamp.
except G. C. C. Countries:

Disengage the 2 claws and remove the radiator support extension.
for G. C. C. Countries:

Disengage the 2 claws and remove the radiator support extension.
| 17. REMOVE RADIATOR SUPPORT EXTENSION RH |
- HINT:
- Use the same procedure as for the LH side.
| 18. REMOVE NO. 2 ENGINE ROOM WIRE |
except G. C. C. Countries:

w/ Fog Light:
- Using a clip remover, remove the 7 clamps.
- Using a clip remover, remove the 7 clamps.
w/o Fog Light:

- Using a clip remover, remove the 6 clamps.
- Using a clip remover, remove the 6 clamps.
for G. C. C. Countries:

w/ Fog Light:
- Using a clip remover, remove the 7 clamps.
- Using a clip remover, remove the 7 clamps.
w/o Fog Light:

- Using a clip remover, remove the 6 clamps.
- Using a clip remover, remove the 6 clamps.
| 19. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY |
except G. C. C. Countries:

Remove the 4 nuts, the 6 bolts and the front bumper reinforcement.
for G. C. C. Countries:

Remove the 4 nuts, the 6 bolts and the front bumper reinforcement.
| 20. REMOVE FRONT BUMPER STONE DEFLECTOR BRACKET |
![]() ![]() |
- HINT:
- Use the same procedure for both sides.
except G. C. C. Countries:
Remove the 2 nuts and the front bumper stone deflector bracket.
for G. C. C. Countries:

Remove the 2 nuts and the front bumper stone deflector bracket.
| 21. REMOVE WINDSHIELD WASHER JAR ASSEMBLY |
Remove the 2 bolts and the windshield washer jar.

| 22. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY LH |
except G. C. C. Countries:

Remove the 4 bolts and the front bumper arm.
for G. C. C. Countries:

Remove the 4 bolts and the front bumper arm.
| 23. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY RH |
- HINT:
- Use the same procedure as for the LH side.


