INSTALLATION
Removal / installation · Vehicles built from Jan 2006
| 1. INSTALL REAR BUMPER ARM SUB-ASSEMBLY LH |
for G. C. C. Countries:

Install the rear bumper arm with the 3 bolts.
- Torque:
- 19 N*m{ 195 kgf*cm , 14 ft.*lbf }
except G. C. C. Countries:

Install the rear bumper arm with the 3 bolts.
- Torque:
- 19 N*m{ 195 kgf*cm , 14 ft.*lbf }
| 2. INSTALL REAR BUMPER ARM SUB-ASSEMBLY RH |
- HINT:
- Use the same procedure as for the LH side.
| 3. INSTALL REAR BUMPER REINFORCEMENT (w/ Rear Bumper Reinforcement) |
Install the rear bumper reinforcement with the 4 nuts.

- Torque:
- 19 N*m{ 195 kgf*cm , 14 ft.*lbf }
| 4. INSTALL REAR BUMPER SIDE SUPPORT LH |
Engage the 2 claws and install the rear bumper side support.

Tighten the screw.
| 5. INSTALL REAR BUMPER SIDE SUPPORT RH |
- HINT:
- Use the same procedure as for the LH side.
| 6. INSTALL REAR BUMPER SIDE RETAINER LH |
Engage the 3 claws and install the rear bumper side retainer.

Tighten the screw.
Install the clip.
| 7. INSTALL REAR BUMPER SIDE RETAINER RH |
- HINT:
- Use the same procedure as for the LH side.
| 8. INSTALL REAR BUMPER COVER |
Engage the 18 claws and install the rear bumper cover.

Tighten the 2 bolts and the 2 screws.

Install the 2 clips.
Remove the protective tape.

| 9. INSTALL REAR BUMPER SIDE SEAL LH |
Install the rear bumper side seal with the 3 clips.

| 10. INSTALL REAR BUMPER SIDE SEAL RH |
- HINT:
- Use the same procedure as for the LH side.
