2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jan 2006

HINT:
The procedure described below is for the LH side. Use the same procedure for the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B136189
  1. Insert a clip remover between the plate and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the front door window regulator handle and clip.

  1. Remove the window regulator handle plate.


3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

B136157E01
  1. Disengage the claw and clip and remove the front door lower frame bracket garnish.


4. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL

B136158
  1. for Driver side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.

  1. B140702
    for Front passenger side with power window:

    1. Remove the screw.

    2. Disengage the 7 claws and 2 clips and remove the front armrest base upper panel.

    3. Disconnect the connector.

  1. B136191
    w/o Power window:

    1. Remove the screw.

    2. Disengage the 5 claws and 2 clips and remove the front armrest base upper panel.


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

  1. B136159
    w/ Power window:

    1. Remove the screw.

    2. B136160
      Disengage the 9 clips.

    3. B136161
      Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.

  1. B136193
    w/o Power window:

    1. Remove the screw.

    2. B136192
      Disengage the 9 clips.

    3. B136194
      Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.


6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

B136162E01
  1. w/ Power mirror:
    Disconnect the connector.

  1. Remove the 3 nuts, disengage the claw and remove the outer rear view mirror.


7. REMOVE FRONT DOOR BELT MOULDING

  1. B134873E02
    Apply protective tape to the door panel in the periphery of the front door belt moulding.

  1. B134874E02
    Using a moulding remover, disengage the 6 claws and remove the front door belt moulding.


8. REMOVE FRONT DOOR GLASS RUN

B136168
  1. Disengage the clip, then remove the front door glass run.


9. REMOVE NO. 1 BLACK OUT TAPE

  1. B134877
    Using an infrared light, heat the black out tape.

    NOTICE:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.

← COMPONENTS (from Jan 2006)INSTALLATION (from Jan 2006) →