INSTALLATION
Removal / installation · Vehicles built from Aug 2005
- HINT:
- The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
| 1. INSTALL NO. 3 BLACK OUT TAPE |
Application precautions (Click here).
Clean the attachment surface (Using an infrared light) (Click here).
Clean the attachment surface (Using a tape removal disc) (Click here).
Apply new No. 3 black out tape to the positions shown in the illustration.


- Installation position:
Mark
Measurement (along surface)
a
+-1 mm (+-0.039 in.)
b
4 mm or more (0.157 in. or more)
c
+-1 mm (+-0.039 in.)
