2005-2008 Yaris · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Jan 2006


COMBINATION METER ASSEMBLY
E126885E03
  1. Disconnect the D1 combination meter assembly connector.

  2. Measure the voltage and resistance of the wire harness side connector.

    Standard: 
    Symbols (Terminals No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    IG2 (D1-1) - Body ground
    B - Body ground
    Ignition switch signal
    Ignition switch OFF ON
    Below 1 V → 10 to 14 V
    ECU-B (D1-2) -
    Body ground
    L - Body ground
    Battery
    Always
    10 to 14 V
    ET (D1-24) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Disconnect the D84 combination meter assembly connector.

  4. Measure the voltage of the wire harness side connector.

    Standard voltage: 
    Symbols (Terminals No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L (D1-3) - Body ground
    V - Body ground
    Fuel level signal
    Ignition switch ON
    10 to 14V
    P/SB (D1-10) - Body ground
    O - Body ground
    Seat belt condition signal (Passenger side)
    Ignition switch ON
    P-BELT indicator light OFF → ON → OFF
    Below 1 V → 10 to 14 V
    → Below 1 V
    ILL+ (D1-14) - Body ground
    G - Body ground
    Taillight signal
    Light control switch OFF → ON
    Below 1 V → 10 to 14 V
    +S (D1-16) - Body ground
    SB - Body ground
    Speed signal (Output)
    Driving at approximately
    20 km/h (12 mph)
    Pulse generation
    (See waveform 1)
    SI (D1-17) - Body ground
    P - Body ground
    Speed signal (Input)
    Driving at approximately
    20 km/h (12 mph)
    Pulse generation
    (See waveform 1)
    CANH (D1-20) - Body ground
    G - Body ground
    CAN communication line
    Ignition switch ON
    Pulse generation
    CANL (D1-21) - Body ground
    W - Body ground
    CAN communication line
    Ignition switch ON
    Pulse generation
    CHG- (D84-1) - Body ground
    L*1 - Body ground
    Charge warning light signal
    Engine start
    Charge warning light ON → OFF
    Below 1V → 10 to 14 V
    SB*2 - Body ground
    SW (D84-2) - Body ground
    V - Body ground
    Brake fluid level warning light signal
    Ignition switch ON
    Brake fluid level warning light ON → OFF
    Below 1 V → 10 to 14 V
    EFI (D84-4) - Body ground
    B - Body ground
    Check engine warning light signal
    Check engine warning light signal ON → OFF
    Below 1V → 10 to 14 V
    FOG*3 (D84-7) - Body ground
    R - Body ground
    Front fog signal
    Ignition switch ON
    Front fog switch OFF → ON
    Below 1V → 10 to 14 V
    B (D84-8) - Body ground
    LG - Body ground
    Turn signal LH signal
    Ignition switch ON
    Turn signal LH indicator light ON
    Below 1V → 10 to 14 V
    → Below 1 V
    PBLT (D84-9) - Body ground
    O - Body ground
    Seat belt warning light signal (Passenger side)
    Ignition switch ON
    Front passenger seat belt warning light OFF → ON → OFF
    Below 1 V → 10 to 14 V
    → Below 1 V
    BEAM- (D84-11) - Body ground
    P - Body ground
    HI-BEAM indicator signal (-)
    BEAM indicator light ON → OFF
    Below 1V → 10 to 14 V
    OIL P (D84-12) - Body ground
    Y - Body ground
    Engine oil pressure signal
    Engine oil pressure warning light ON → OFF
    Below 1V → 10 to 14 V
    BEAM+ (D84-14) - Body ground
    GR - Body ground
    HI-BEAM indicator signal (+)
    Always
    10 to 14 V
    B (D84-15) - Body ground
    BR - Body ground
    Turn signal RH signal
    Ignition switch ON
    Turn signal RH indicator light OFF → ON → OFF
    Below 1V → 10 to 14 V
    → Below 1 V
    IND (D84-16) - Body ground
    G - Body ground
    Taillight indicator signal
    Headlight dimmer switch
    (TAIL) OFF → ON
    Below 1V → 10 to 14 V
    ODO/TRIP (D84-17) - Body ground
    L - Body ground
    Hazard switch signal
    Ignition switch ON
    5 V
    CLOCK (D84-18) - Body ground
    R - Body ground
    Hazard switch signal
    Ignition switch ON (ACC)
    5 V
    RETURN (D84-19) - Body ground
    GR - Body ground
    Hazard switch signal
    Ignition switch ON
    Below 1 V
    RLCY (D84-20) - Body ground
    G - Body ground
    Rear door courtesy switch signal (LH)
    Rear door (LH)
    CLOSED → OPEN
    10 to 14 V → Below 1 V
    RRCY (D84-21) - Body ground
    L - Body ground
    Rear door courtesy switch signal (RH)
    Rear door (RH)
    CLOSED → OPEN
    10 to 14 V → Below 1 V
    JB ECU (D84-22) - Body ground
    Y - Body ground
    JB ECU Signal
    Rear door (LH or RH)
    CLOSED → OPEN
    10 to 14 V → Below 1 V
    *1: w/o daytime running light system
    *2: w/ daytime running light system
    *3: w/ fog light
    If the result is not as specified, the combination meter assembly may have a malfunction.

    1. E115032E01
      Waveform 1: Using an oscilloscope
      Terminal Connections
      +S (D1-16) and Body ground
      SI (D1-17) and Body ground
      Tester Range
      5V/DIV, 20ms/DIV
      Vehicle Condition
      Driving at approximately 20km/h (12mph)

      HINT:
      As the vehicle speed increases, the cycle of the signal waveform narrows.

  5. Reconnect the combination meter assembly connectors.


MAIN BODY ECU
If the result is not as specified, there may be a malfunction in the wire harness.
E114510E06
B108641E03
Standard: 
Symbols (Terminals No.)
Wiring Color
Terminal Description
Condition
Specified Condition
RRCY (4A-5) - Body ground
Y - W-B
Rear door courtesy switch signal (LH and RH)
Rear door (LH and RH) CLOSED → OPEN
10 to 14 V → Below 1 V
BCTY (4A-7) - Body ground
SB - W-B
Luggage door courtesy switch signal
Back door CLOSED → OPEN
10 to 14 V → Below 1 V
DCTY (4A-21) - Body ground
R - W-B
Front door courtesy switch signal (Driver Side)
Front door (Driver Side) CLOSED → OPEN
10 to 14 V → Below 1 V
PCTY (4A-24) - Body ground
L - W-B
Front door courtesy switch signal (Passenger Side)
Front door (Passenger Side) CLOSED → OPEN
10 to 14 V → Below 1 V
PKB (4C-2) - Body ground
Y - W-B
Parking brake signal
Parking brake warning light ON → OFF
Below 1 V → 10 to 14 V
KSW (4D-7) - Body ground
Y - W-B
Key switch condition signal
Key inserted → Removed
Below 1 V → 10 to 14 V
GND1 (4E-17) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
CANL (D33-22) - Body ground
W - Body ground
CAN communication line
Ignition switch ON
Pulse generation
CANH (D33-23) - Body ground
R - Body ground
CAN communication line
Ignition switch ON
Pulse generation
DBKL(D33-9) - Body ground
W - Body ground
Seat belt condition signal (Driver side)
Driver seat belt warning light OFF → ON
10 to 14 V → Below 1 V

COMBINATION METER INTERNAL CIRCUIT
*: w/ ABS
E126914E01
E126915E01
E126918E01
Connectors 
Terminal No.
Wire Harness Side
D1
1
Ignition switch
2
Battery
3
Fuel sender gauge assembly
10
Front seat inner belt assembly (Passenger side)
14
T-LP relay
16
ECM, Power steering ECU
17
Brake actuator *
20
CAN communication line
21
CAN communication line
24
Body ground
D84
1
Generator (Alternator)
2
Brake fluid level warning switch
4
ECM
7
Front fog light relay *
8
Turn signal flasher relay
9
Front passenger seat belt warning light
11
Headlight dimmer switch
12
Engine oil pressure switch
14
Battery
15
Turn signal flasher relay
16
T-LP relay
17
Hazard switch
18
Hazard switch
19
Hazard switch
20
Rear left courtesy switch
21
Rear right courtesy switch
22
Main body ECU
← PROBLEM SYMPTOMS TABLE (from Aug 2007)DIAGNOSIS SYSTEM (from Jan 2006) →