2005-2008 Yaris · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. INSTALL INPUT SHAFT OIL SEAL RING

C059970
  1. Coat 2 new input shaft oil seal rings with ATF, and install them onto the input shaft.


2. INSTALL DIRECT CLUTCH PISTON O-RING

C059969
  1. Coat a new direct clutch piston O-ring (outer) with ATF, and install it onto the direct clutch.

  1. C059940
    Coat a new direct clutch piston O-ring (inner) with ATF, and install it onto the input shaft.


3. INSTALL DIRECT CLUTCH PISTON SUB-ASSEMBLY

C059974
  1. Coat the direct clutch piston with ATF, and install it onto the input shaft.


4. INSTALL DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

D025200E01
  1. Using SST, a press and snap ring pliers, install the direct clutch spring onto the input shaft with the snap ring.

    SST
    09387-00020  


5. INSTALL DIRECT CLUTCH DISC

D025201E01
  1. Coat the 2 clutch plates, 2 clutch discs and clutch flange with ATF and install them onto the input shaft with the snap ring.


6. INSPECT PISTON STROKE OF DIRECT CLUTCH

C059977
  1. Install the input shaft assembly onto the oil pump.

  1. Using a dial indicator and measuring terminal, measure the forward clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard piston stroke:
    0.40 to 0.80 mm (0.0157 to 0.0315 in.)

    Flange thickness:
    Mark
    Thickness
    1
    3.0 mm (0.118 in.)
    2
    3.2 mm (0.126 in.)
    3
    3.4 mm (0.134 in.)

← INSPECTION (from Aug 2005)COMPONENTS (from Aug 2005) →