2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Nov 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/front seat side airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE FRONT SEAT HEADREST ASSEMBLY

  1. B124372E01
    Push in the lock button of the front seat headrest support and remove the front seat headrest.


3. REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)

  1. B126911
    Remove the front seat under tray.


4. REMOVE FRONT SEAT ASSEMBLY

  1. B124373E01
    Disconnect the buckle switch connector.

  1. w/ Front Seat Side Airbag:

    1. Slide the slider and disconnect the airbag connector.

  1. B124375
    Move the front seat to its most rearward position.

  1. Using "Torx" socket wrench E10, remove the 2 bolts from the front side.

  1. Move the front seat to its most forward position.

  1. Using "Torx" socket wrench E10, remove the 2 bolts from the rear side and the front seat.


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY

  1. B124389
    for Driver Side:

    1. Disengage the claw and remove the buckle switch connector.

    2. Using a clip remover, remove the 2 clamps.

    3. Remove the wire harness from the claw of the front seat frame adjuster.

    4. w/ Seat Heater System:

      1. Disconnect the seat heater connector.

  1. B124386
    for Front Passenger Side:

    1. Disengage the claw and remove the buckle switch connector.

    2. Disconnect the occupant detection sensor connector.

    3. Using a clip remover, remove the 2 clamps.

    4. Remove the wire harness from the claw of the front seat frame adjuster.

    5. w/ Seat Heater System:

      1. Disconnect the seat heater connector.

  1. B124387
    Remove the bolt and the front seat inner belt.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →