2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


2. REMOVE FRONT DOOR SCUFF PLATE

  1. B114284
    Disengage the 8 claws and remove the front door scuff plate.


3. REMOVE REAR DOOR SCUFF PLATE

  1. B114287
    Disengage the 6 claws and remove the rear door scuff plate.


4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

  1. B114419
    Remove the front door opening trim weatherstrip to the extent that the center pillar upper and lower garnish can be removed.


5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP

  1. B114420
    Remove the rear door opening trim weatherstrip to the extent that the center pillar upper and lower garnish can be removed.


6. REMOVE CENTER PILLAR LOWER GARNISH

  1. B114297
    Disengage the 2 clips and the 2 claws and remove the center pillar lower garnish.


7. REMOVE SEAT BELT ANCHOR COVER CAP

  1. B114421E01
    Pull portion A, shown in the illustration, toward you, remove the 2 claws on the lower side followed by the claw on the upper side. Then remove the seat belt anchor cover cap.


8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

  1. B114294
    Remove the anchor plate cover.

  1. B114295
    Remove the bolt and the anchor plate.

  1. B114296
    Remove the bolt and the through anchor.

  1. B114422E01
    Disconnect the pretensioner connector.

    1. Using a screwdriver, release the locking button.

    2. Using a screwdriver, disconnect the pretensioner connector.

  1. B114423
    Remove the 2 bolts, the 2 hooks and the retractor.


9. REMOVE CENTER PILLAR UPPER GARNISH

  1. B114298
    Disengage the 3 clips and the 2 hooks and remove the center pillar upper garnish.


10. REMOVE SHOULDER BELT ANCHOR COVER

  1. B114424
    Disengage the 2 claws and remove the shoulder belt anchor cover.


11. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

  1. B114425
    Remove the 2 bolts, the hook and the front shoulder belt anchor adjuster.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →