INSTALLATION
Removal / installation · Vehicles built from Nov 2005
- NOTICE:
- Always use "Torx" socket wrench E10 when installing the rear seat.
| 1.
INSTALL REAR SEAT INNER BELT ASSEMBLY |
 |
- Install the rear seat inner belt with the bolt.
-
Torque:
- 42 N*m{
430 kgf*cm
, 31 ft.*lbf
}
- NOTICE:
- Do not place the anchor plate over the convex areas of the rear seat frame adjuster.
Install the belt into the rear seat cushion band.
- Install the rear seat cushion.
Using "Torx " socket wrench E10, tighten the 3 bolts in the sequence shown in the illustration.
-
Torque:
- 37 N*m{
375 kgf*cm
, 27 ft.*lbf
}
| 2.
INSTALL REAR SEAT LEG COVER
|
 |
- Engage the 6 claws and install the No. 2 rear seat leg cover.