INSTALLATION
Removal / installation · Vehicles built from Aug 2005
- NOTICE:
- Always use "Torx" socket wrench E10 when installing the rear seat.
| 1. INSTALL REAR SEAT INNER BELT ASSEMBLY |
Install the rear seat inner belt with the bolt.

- Torque:
- 42 N*m{ 430 kgf*cm , 31 ft.*lbf }
- NOTICE:
- Do not place the anchor plate over the convex areas of the rear seat back frame.
| 2. INSTALL REAR SEAT ASSEMBLY |
Insert the 2 location pins through the 2 body holes and install the rear seat.

Using "Torx" socket wrench E10, install the 4 bolts in the sequence shown in the illustration.
- Torque:
- 37 N*m{ 375 kgf*cm , 27 ft.*lbf }
Install the rear seat cushion.

Using "Torx" socket wrench E10, install the 2 bolts in the sequence shown in the illustration.
- Torque:
- 37 N*m{ 375 kgf*cm , 27 ft.*lbf }
| 3. INSTALL NO. 1 REAR SEAT LEG COVER |
Engage the 4 claws and install the No. 1 rear seat leg cover.

| 4. INSTALL DECK FLOOR BOX (w/ Deck Board) |
Set the deck floor box and lock the 2 knobs.

| 5. INSTALL SPARE WHEEL COVER ASSEMBLY (w/ Deck Board) |
Install the spare wheel cover.

| 6. INSTALL DECK BOARD SUB-ASSEMBLY (w/ Deck Board) |
Set the deck board and lock the 2 knobs.

| 7. INSTALL REAR FLOOR CARPET ASSEMBLY (w/o Deck Board) |
Install the rear floor carpet.

| 8. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim) |
Engage the 2 claws and install the package tray trim panel.

Install the 5 pieces of hook tape.
Install the 2 package tray trim suspenders.
