REMOVAL
Removal / installation · Vehicles built from Aug 2005
- HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- Use the same procedure for both the RH and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() ![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the rear door armrest plug.
Remove the 2 screws.

Disengage the 7 clips.

Disconnect the connector.
Disconnect the rear door lock remote control cable and rear door inside locking cable and remove the rear door trim board.

| 3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR |
![]() ![]() |
Disengage the set plate and remove the power window regulator switch.


