DISASSEMBLY
Removal / installation · Vehicles built from Jan 2006
| 1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP |
![]() ![]() |
for One-touch Clamp Type:
Using a screwdriver, release the staked part of the boot clamp and separate the boot clamp.
for Hook Clamp Type:

Using needle-nose pliers, disengage the hook and remove the boot clamp.
| 2. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP |
![]() ![]() |
for One-touch Clamp Type:
Using a screwdriver, release the staked part of the boot clamp and separate the boot clamp.
for Hook Clamp Type:

Using needle-nose pliers, disengage the hook and remove the boot clamp.
| 3. SEPARATE FRONT AXLE INBOARD JOINT BOOT |
Separate the inboard joint boot from the inboard joint.
| 4. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY |
Remove the old grease from the inboard joint.
Place matchmarks on the inboard joint and outboard joint shaft.

- NOTICE:
- Do not cause any damage when placing the marks.
Remove the inboard joint from the outboard joint shaft.
Fix the outboard joint shaft in a vise between aluminum plates.
- NOTICE:
- Do not overtighten the vise.
Using a snap ring expander, remove the snap ring.

Place matchmarks on the tripod joint and outboard joint shaft.

- NOTICE:
- Do not cause any damage when placing the marks.
Using a brass bar and hammer, remove the tripod joint.
- NOTICE:
- Do not tap the roller.
Remove the inboard joint boot No. 2 clamp, the inboard joint boot and the inboard joint boot clamp.
| 5. REMOVE FRONT DRIVE SHAFT DAMPER CLAMP (for RH Side) |
![]() ![]() |
Using needle-nose pliers, disengage the hook and remove the damper clamp.
| 6. REMOVE FRONT DRIVE SHAFT DAMPER (for RH Side) |
| 7. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP |
![]() ![]() |
Using a screwdriver, release the staked part of the boot clamp and remove the boot clamp.
| 8. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
![]() ![]() |
Using a screwdriver, release the staked part of the boot clamp and remove the boot clamp.
| 9. REMOVE FRONT AXLE OUTBOARD JOINT BOOT |
Remove the outboard joint boot from the outboard joint shaft.
Remove the old grease from the outboard joint.
| 10. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING |
![]() ![]() |
Using a screwdriver, remove the snap ring.
| 11. REMOVE FRONT DRIVE SHAFT DUST COVER |
![]() ![]() |
Using SST and a press, remove the dust cover.
- SST
- 09950-00020
- NOTICE:
- Do not drop the inboard joint.







