2005-2008 Yaris · Service Manual DRIVE LINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2006


1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP

  1. C148754
    Using a screwdriver, release the staked part of the boot clamp and separate the boot clamp.


2. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP

  1. C152370
    Using a screwdriver, release the staked part of the boot clamp and separate the boot clamp.


3. SEPARATE FRONT AXLE INBOARD JOINT BOOT
  1. Separate the inboard joint boot from the inboard joint grommet.


4. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY
  1. Remove the old grease from the inboard joint.

  1. C158439E01
    Place matchmarks on the inboard joint and outboard joint shaft.

    NOTICE:
    Do not cause any damage when placing the marks.

  1. Remove the inboard joint from the outboard joint shaft.

  1. Fix the outboard joint shaft in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. C160818
    Using a snap ring expander, remove the snap ring.

  1. F047435E01
    Place matchmarks on the tripod joint and outboard joint shaft.

    NOTICE:
    Do not cause any damage when placing the marks.

  1. Using a brass bar and hammer, remove the tripod joint.

    NOTICE:
    Do not tap the rollers.

  1. Remove the No. 2 inboard joint boot clamp, the inboard joint boot and the inboard joint boot clamp.


5. REMOVE FRONT AXLE INBOARD JOINT GROMMET
  1. Remove the inboard joint grommet from the inboard joint.


6. REMOVE FRONT DRIVE SHAFT DAMPER CLAMP (for RH Side)

  1. C158440
    Using needle-nose pliers, disengage the hook and remove the damper clamp.


7. REMOVE FRONT DRIVE SHAFT DAMPER (for RH Side)

8. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP

  1. C107963
    Using a screwdriver, release the staked part of the boot clamp and remove the boot clamp.


9. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP

  1. C107964
    Using a screwdriver, release the staked part of the boot clamp and remove the boot clamp.


10. REMOVE FRONT AXLE OUTBOARD JOINT BOOT
  1. Remove the outboard joint boot from the outboard joint shaft.

  1. Remove the old grease from the outboard joint.


11. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING

  1. C057543
    Using a screwdriver, remove the snap ring.


12. REMOVE FRONT DRIVE SHAFT DUST COVER

  1. F047437E01
    Using SST and a press, remove the dust cover.
    SST
    09950-00020  

    NOTICE:
    Do not drop the inboard joint.

← REMOVAL (from Nov 2006)REASSEMBLY (from Nov 2006) →