INSTALLATION
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL ELECTRICAL KEY ANTENNA |
![]() ![]() |
Install the electrical key antenna with the 2 nuts.
Connect the connector.
| 2. INSTALL REAR BUMPER COVER |
Connect the license plate light connector.

Engage the 4 claws and install the rear bumper.
Engage the 8 claws.

w/ Floor Under Cover:

Tighten the 2 bolts.
Install the clip.
w/o Floor Under Cover:

Tighten the 2 bolts.
Install the 2 clips.
Remove the protective tape.

| 3. REMOVE FLOOR UNDER COVER (w/ Floor Under Cover) |
Install the rear bumper retainer lower with the 5 clips.

| 4. INSTALL REAR BUMPER SIDE SEAL LH |
Install the rear bumper side seal with the 2 clips.

| 5. INSTALL REAR BUMPER SIDE SEAL RH |
- HINT:
- Use the same procedure as for the LH side.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

