2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE REAR BUMPER SIDE SEAL LH

  1. B114386
    Using a clip remover, remove the 2 clips and the rear bumper side seal.


3. REMOVE REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.


4. REMOVE FLOOR UNDER COVER (w/ Floor Under Cover)

  1. B114627
    Using a clip remover, remove the 5 clips and the floor under cover.


5. REMOVE REAR BUMPER COVER

  1. B114630E01
    Apply protective tape as shown in the illustration.

  1. B126917
    w/ Floor Under Cover:

    1. Using a clip remover, remove the clip.

    2. Remove the 2 bolts.

  1. B114629
    w/o Floor Under Cover:

    1. Using a clip remover, remove the 2 clips.

    2. Remove the 2 bolts.

  1. B114628E01
    Insert a clip remover into the engaged portion between the rear bumper and rear bumper side retainer, 20 mm (0.787 in.) from the end of the rear bumper arch.

  1. Pull the rear bumper outward while pushing the rear bumper side retainer downward.

  1. B114621E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws.

  1. B114623E01
    Disengage the 4 claws and remove the rear bumper cover.

  1. Disconnect the license plate light connector.


6. REMOVE ELECTRICAL KEY ANTENNA

B116950
  1. Disconnect the connector.

  1. Remove the 2 nuts and the electrical key antenna.

← COMPONENTS (from Aug 2005)INSPECTION (from Aug 2005) →