2005-2008 Yaris · Service Manual BODY

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH FRONT

  1. B122848E01
    Inspect the operation of the PTC inside the power window regulator motor.

    NOTICE:
    The work must be performed with the power window regulator and door glass installed on the vehicle.


    1. w/ Jam protection function:
      Connect an electrical tester DC 400 A probe to the wire harness of terminal 1 or 2.

      NOTICE:
      Match the arrow mark of the probe with the direction of the current flow.

    2. w/o Jam protection function:
      Connect an electrical tester DC 400 A probe to the wire harness of terminal 1.

      NOTICE:
      Match the arrow mark of the probe with the direction of the current flow.

    3. Fully close the door glass by pressing the power window UP switch. Wait for approximately 60 seconds.

    4. Continue to press the power window UP switch and measure how long it takes for the electrical current to change from a range of 16 to 28 A to approximately 1 A (Inspection of current shut-off).

      Standard:
      4 to 90 seconds

    5. Check that the door glass moves downward when the power window DOWN switch is pressed.
      If the result is not as specified, replace the power window regulator motor.


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH FRONT

  1. B122848E01
    Inspect the operation of the PTC inside the power window regulator motor.

    NOTICE:
    The work must be performed with the power window regulator and door glass installed on the vehicle.


    1. w/ Jam protection function:
      Connect an electrical tester DC 400 A probe to the wire harness of terminal 1 or 2.

      NOTICE:
      Match the arrow mark of the probe with the direction of the current flow.

    2. w/o Jam protection function:
      Connect an electrical tester DC 400 A probe to the wire harness of terminal 2.

      NOTICE:
      Match the arrow mark of the probe with the direction of the current flow.

    3. Fully close the door glass by pressing the power window UP switch. Wait for approximately 60 seconds.

    4. Continue to press the power window UP switch and measure how long it takes for the electrical current to change from a range of 16 to 28 A to approximately 1 A (Inspection of current shut-off).

      Standard:
      4 to 90 seconds

    5. Check that the door glass moves downward when the power window DOWN switch is pressed.
      If the result is not as specified, replace the power window regulator motor.

← COMPONENTS (from Aug 2005)REMOVAL (from Aug 2005) →