2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Jan 2006

CAUTION:
Some of the these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

  1. B114569E01
    Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.


3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  1. B106371
    Release the 2 knobs and remove the deck board.


4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)

  1. B138393
    Remove the spare wheel cover.


5. REMOVE DECK FLOOR BOX RH (w/ Deck Board)

  1. B106372
    Release the 2 knobs and remove the deck floor box.


6. REMOVE DECK FLOOR BOX LH (w/ Deck Board)

HINT:
Use the same procedure as for the RH side.


7. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

  1. B138392
    Remove the rear floor carpet.


8. REMOVE NO. 1 REAR SEAT LEG COVER

  1. B124298
    Disengage the 4 claws and remove the No. 1 rear seat leg cover.


9. REMOVE NO. 2 REAR SEAT LEG COVER

  1. B124330
    Disengage the 6 claws and remove the No. 2 rear seat leg cover.


10. REMOVE REAR SEAT ASSEMBLY RH

  1. B124299
    Using "Torx" socket wrench E10, remove the 2 bolts and pull up the rear seat cushion.

  1. B124300
    Using "Torx" socket wrench E10, remove the 2 bolts and rear seat.


11. REMOVE REAR SEAT ASSEMBLY LH

  1. B124331
    Using "Torx" socket wrench E10, remove the 3 bolts and pull up the rear seat cushion.

  1. B124315
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat.


12. REMOVE FRONT DOOR SCUFF PLATE RH

  1. B114494
    Disengage the 8 claws and remove the front door scuff plate.


13. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

  1. B138507
    Remove the front door opening trim weatherstrip.


14. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

  1. B114498
    Remove the belt of the rear seat outer belt from the rear seat shoulder belt hanger.

  1. B114499
    Disengage the 8 clips, the retainer and the 10 claws and remove the front quarter trim panel.


15. REMOVE SIDE AIRBAG SENSOR ASSEMBLY

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. B106572E01
    Slide the outer housing and detach the airbag connector.

  1. B106573E01
    Remove the bolt, disengage the hook and remove the side airbag sensor.

← ON-VEHICLE INSPECTION (from Jan 2006)INSTALLATION (from Jan 2006) →