REMOVAL
Removal / installation · Vehicles built from Jan 2006
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT BUMPER COVER |
Apply protective tape, as shown in the illustration.

Remove the 7 screws and 3 bolts.

Remove the 2 screw grommets.
Remove the 6 clips.
w/ Fog Light:

Disengage the 6 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
w/o Fog Light:

Disengage the 6 claws and remove the front bumper cover.
Remove the 2 clips and the screw grommet.

| 3. REMOVE AMBIENT TEMPERATURE SENSOR |
![]() ![]() |
Disconnect the connector.
Disengage the clamp and remove the ambient temperature sensor.

